Made in the USA
Click on a model below to find specification info:
-
Lane Shark Hammerhead FEM
The Lane Shark Hammerhead is the only patented, hydraulically articulated, multi-position brush cutter for tractors with a minimum weight of 3,000lbs and a hydraulic flow range of 8.5-20gpm. Supported by a cutting diameter of 44”, the Hammerhead can tackle overgrown vegetation and cut the time spent on brush clearing jobs by more than half, and a wide range of cutting positions makes sure you get the job done right. Its cutting positions, which are vertical and offset from 25 to 55 degrees, enable it to easily maneuver around obstacles and reach difficult areas. Buy the Lane Shark Hammerhead brush cutter to simplify land management. *NOT COMPATIBLE WITH REAR REMOTES* **NOT COMPATBILE WITH SKID STEERS**Read more -
Lane Shark LS3 FEM
Manufactured in the panhandle of Florida, the original FEL mounted brush cutter designed for the compact to midsize tractor. American owned using American parts. Reduce the workload of clearing hunting lanes, roads, pond edges, underbrush, and much more. Forget the pole saws and ladders! With 11 cutting positions there's no job the Lane Shark Brush Cutter can't handle. Cut vertically, level with the ground, or 25°, 35°, & 45°. Fits most compact or midsize tractors with SSQA or the John Deere 400 & 500 series.Read more -
Lane Shark LS4 FEM
Manufactured in the panhandle of Florida, the original FEL mounted brush cutter designed for the compact to midsize tractor. American owned using American parts. Reduce the workload of clearing hunting lanes, roads, pond edges, underbrush, and much more. Forget the pole saws and ladders! With 11 cutting positions there's no job the Lane Shark Brush Cutter can't handle. Cut vertically, level with the ground, or 25°, 35°, & 45°. Fits most compact or midsize tractors with SSQA or the John Deere 400 & 500 series.Read more
